Table of Contents
Advertisement
Figure 32 Pop up for Access Point mode
Click OK. The Web Configurator refreshes once the change to Access Point mode
is successful.
6.3.2 Accessing the Web Configurator in Access Point
Mode
Log in to the Web Configurator in Access Point mode, do the following:
Connect your computer to the LAN port of the MWR222.
1
The default IP address of the MWR222 is "192.168.10.2". In this case,
2
your computer must have an IP address in the range between
"192.168.10.3" and "192.168.10.254".
Click Start > Run on your computer in Windows. Type "cmd" in the dialog
3
box. Enter "ipconfig" to show your computer's IP address. If your
computer's IP address is not in the correct range then see
information on changing your computer's IP address.
After you've set your computer's IP address, open a web browser such as
4
Internet Explorer and type "192.168.10.2" as the web address in your web
browser.
Note: After clicking Login, see the screens described in the sections following this.
6.3.3 Configuring your WLAN, Bandwidth
Management and Maintenance Settings
The configuration of wireless, bandwidth management and maintenance settings
in Access Point mode is the same as for Router Mode.
• See
Chapter 10
for information on the configuring your wireless network.
• See
Chapter 20
for information on configuring your Bandwidth Management
screen.
MWR222 User's Guide
47
Appendix C
for
Advertisement
Table of Contents
Troubleshooting
