Advanced Wan Screen - ZyXEL Communications MWR222 - V1.0 Manual

10.6 Advanced WAN Screen

Use this screen to enable Multicast and enable Auto-bridge.
Note: The categories shown in this screen are independent of each other.
To change your MWR222's advanced WAN settings, click Network > WAN >
Advanced. The screen appears as shown.
Figure 76 Network > WAN > Advanced
The following table describes the labels in this screen.
Table 47 Network > WAN > Advanced
LABEL DESCRIPTION
Multicast Setup
Select IGMPv1/v2 to enable multicasting. This applies to traffic
routed from the WAN to the LAN.
Multicast
Select None to disable this feature. This may cause incoming
traffic to be dropped or sent to all connected network devices.
Auto-bridge
Select this option to have the MWR222 switch to bridge mode
Enable Auto-bridge automatically when the MWR222 gets a WAN IP address in the
mode range of 192.168.x.y (where x and y are from zero to nine) no
matter what the LAN IP address is.
Apply Click Apply to save your changes back to the MWR222.
Reset Click Reset to begin configuring this screen afresh.
MWR222 User's Guide
123