Wireless Lan General Screen - ZyXEL Communications MWR222 - V1.0 Manual

Status
Rate
Summary
BW MGMT Monitor
DHCP Table
Packet Statistics

7.5 Wireless LAN General Screen

Use this screen to configure the wireless LAN settings of your MWR222. Go to
Configuration > Wireless LAN > General to open the following screen.
Figure 40 WISP Mode: LAN > General Screen
MWR222 User's Guide
For the LAN and WAN ports, this field displays Down (line is down) or
Up (line is up or connected).
For the WLAN, it displays Up when the WLAN is enabled or Down when
the WLAN is disabled.
For the LAN ports, this displays the port speed and duplex setting or N/A
when the line is disconnected.
For the WAN port, it displays the port speed and duplex setting if you're
using Ethernet encapsulation and Idle (line (ppp) idle), Dial (starting to
trigger a call) and Drop (dropping a call) if you're using PPPoE or PPTP
encapsulation. This field displays N/A when the line is disconnected.
For the WLAN, it displays the maximum transmission rate when the
WLAN is enabled and N/A when the WLAN is disabled.
Click Details... to go to the Monitor >
Use this screen to view the amount of network bandwidth that
applications running in the network are using.
Click Details... to go to the Monitor >
this screen to view current DHCP client information.
Click Details... to go to the Monitor >
Use this screen to view port status and packet specific statistics.
60
BW MGMT Monitor screen.
DHCP Table screen. Use
Packet Statistics screen.