ZyXEL Communications MWR222 - V1.0 Manual page 52

Figure 35 Network > LAN > IP
The table below describes the labels in the screen.
Table 22 Network > LAN > IP
LABEL DESCRIPTION
Click this to deploy the MWR222 as an access point in the network.
When you enable this, the MWR222 gets its IP address from the
network's DHCP server (for example, your ISP). Users connected to the
MWR222 can now access the network (i.e., the Internet if the IP address
is given by the ISP).
Get from
DHCP Server
The Web Configurator may no longer be accessible unless you know the
IP address assigned by the DHCP server to the MWR222. You need to
reset the MWR222 to be able to access the Web Configurator again.
Also when you select this, you cannot enter an IP address for your
MWR222 in the field below.
Use Defined Click this if you want to specify the IP address of your MWR222. Or if
LAN IP your ISP or network administrator gave you a static IP address to access
Address the network or the Internet.
Type the IP address in dotted decimal notation. The default setting is
IP Address 192.168.10.2. If you change the IP address you will have to log in again
with the new IP address.
The subnet mask specifies the network number portion of an IP address.
IP Subnet Your MWR222 will automatically calculate the subnet mask based on the
Mask IP address that you assign. Unless you are implementing subnetting, use
the subnet mask computed by the MWR222.
Gateway IP Enter a Gateway IP Address (if your ISP or network administrator gave
Address you one) in this field.
DNS Assignment
MWR222 User's Guide
52