General Wireless Lan Screen - ZyXEL Communications MWR222 - V1.0 Manual

9.4 General Wireless LAN Screen

Use this screen to enable the Wireless LAN, enter the SSID and select the
wireless security mode.
Note: If you are configuring the MWR222 from a computer connected to the wireless
LAN and you change the MWR222's SSID, channel or security settings, you will
lose your wireless connection when you press Apply to confirm. You must then
change the wireless settings of your computer to match the MWR222's new
settings.
Click Network > Wireless LAN to open the General screen.
Figure 56 Network > Wireless LAN > General
The following table describes the general wireless LAN labels in this screen.
Table 31 Network > Wireless LAN > General
LABEL DESCRIPTION
Wireless Setup
This is turned on by default.
Wireless LAN
You can turn the wireless LAN on or off using the switch at the rear panel
of the MWR222. The current wireless state is reflected in this field.
MWR222 User's Guide
85