What You Need To Know; Setting Your Mwr222 To Ap Mode - ZyXEL Communications MWR222 - V1.0 Manual

• Use the LAN screen to set the IP address for your MWR222 acting as an access
point.

6.3 What You Need to Know

See Chapter 10 for a tutorial on setting up a network with the MWR222 as an
access point.

6.3.1 Setting your MWR222 to AP Mode

Log into the Web Configurator if you haven't already. See the Quick Start
1
Guide for instructions on how to do this.
To use your MWR222 as an access point, go to Maintenance > Sys OP
2
Mode > General and select Access Point mode.
Figure 31 Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As
soon as you do, your MWR222 is already in Access Point mode.
When you select Access Point Mode, the following pop-up message
3
window appears.
MWR222 User's Guide
46