Wireless Router/Ap Troubleshooting - ZyXEL Communications MWR222 - V1.0 Manual

If the MWR222 restarts automatically, wait for the MWR222 to finish restarting,
and log in to the Web Configurator. The password is "1234".
If the MWR222 does not restart automatically, disconnect and reconnect the
MWR222's power. Then, follow the directions above again.
31.5 Wireless Router/AP
Troubleshooting
I cannot access the MWR222 or ping any computer from the WLAN
(wireless AP or router).
Make sure the wireless LAN is enabled on the MWR222
1
Make sure the wireless adapter on the wireless station is working
2
properly.
Make sure the wireless adapter installed on your computer is IEEE
3
802.11 compatible and supports the same wireless standard as the
MWR222.
Make sure your computer (with a wireless adapter installed) is within
4
the transmission range of the MWR222.
Check that both the MWR222 and your wireless station are using the
5
same wireless and wireless security settings.
Make sure traffic between the WLAN and the LAN is not blocked by the
6
firewall on the MWR222.
Make sure you allow the MWR222 to be remotely accessed through the
7
WLAN interface. Check your remote management settings.
• See the chapter on Wireless LAN in the User's Guide for more information.
I set up URL keyword blocking, but I can still access a website that
should be blocked.
Make sure that you select the Enable URL Keyword Blocking check box in the
Content Filtering screen. Make sure that the keywords that you type are listed in
the Keyword List.
If a keyword that is listed in the Keyword List is not blocked when it is found in
a URL, customize the keyword blocking using commands. See the Customizing
Keyword Blocking URL Checking section in the Content Filter chapter.
I can access the Internet, but I cannot open my network folders.
MWR222 User's Guide
210