Connecting To The Internet From An Access Point - ZyXEL Communications MWR222 - V1.0 Manual

 After filling in all the account information, click the "Connect" button to
save the information to the router's memory and make the wireless 3G
connection.
 The USB LED starts to blink fast, indicating MWR222 is connecting. When
the mobile WAN is connected, the USB LED changes solid on. However, if
the Ethernet port is configured to WAN, and is connected to a wired WAN,
the mobile WAN will be used as the backup WAN so the USB LED shows
slow blinking.
 When a 3G USB adapter is removed from the USB port, the USB LED will
turn off in about 10 seconds. Do not re-insert the 3G USB adapter into the
USB port until the USB LED has turned off, or 10 seconds have passed.
 The Data Usage Count, if enabled, will be written to MWR222 internal
storage when the 3G USB adapter is removed. Do not power off MWR222
before the USB LED has turned off, or 10 seconds have passed.
8.3 Connecting to Internet from an Access
Point
This section gives you an example of how to set up an access point (AP) and
wireless client (a notebook (B), in this example) for wireless communication. B
can access the Internet through the access point wirelesslyMWR222 When the
MWR is configured in AP mode, it has to connect to a broadband gateway (wired
or wireless router with broadband connection) . Local computer(s) can get IP via
wireless connection passed by MWR from the broadband gateway, then gain
Internet access.
Figure 46 Wireless Access Point mode
Internet
MWR222 User's Guide
72