Table of Contents
Advertisement
Enable Firewall Rule
Enable Firewall
Select this check box to activate the firewall rules that you define (see
Rule
Add Firewall Rule below)
Apply
Click Apply to save the settings.
Add Firewall Rule
Service Name
Enter a name that identifies or describes the firewall rule.
Enter the MAC address of the computer for which the firewall rule
MAC Address
applies.
Enter the IP address of the computer to which traffic for the application
or service is entering.
Dest IP Address
The MWR222 applies the firewall rule to traffic initiating from this
computer.
Enter the IP address of the computer that initializes traffic for the
application or service.
Source IP
Address
The MWR222 applies the firewall rule to traffic initiating from this
computer.
Select the protocol (TCP, UDP, ICMP or None) used to transport the
Protocol
packets for which you want to apply the firewall rule.
Dest Port
Enter the port number/range of the destination that define the traffic
Range
type, for example TCP port 80 defines web traffic.
Source Port
Enter the port number/range of the source that define the traffic type,
Range
for example TCP port 80 defines web traffic.
Add Rule
Click Add to save the firewall rule.
Firewall Rule
#
This is your firewall rule number. The ordering of your rules is
important as rules are applied in turn.
Service Name
This is a name that identifies or describes the firewall rule.
MWR222 User's Guide
155
Advertisement
Table of Contents
Troubleshooting
