ZyXEL Communications MWR222 - V1.0 Manual page 76

Follow the steps below to configure the wireless settings on your MWR222.
The instructions require that your hardware is connected (see the Quick Start
Guide) and you are logged into the Web Configurator through your LAN
connection.
Open the Wireless LAN > General screen in the AP's Web Configurator.
1
Make sure the Enable Wireless LAN check box is selected.
2
Enter SSID_Example3 as the SSID and select a channel.
3
Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-
4
sharedkey in the Pre-Shared Key field. Click Apply.
Figure 49 Tutorial: Network > Wireless LAN > General
Open the Status screen. Verify your wireless and wireless security
5
settings under Device Information and check if the WLAN connection is
up under Interface Status.
MWR222 User's Guide
76