Wps Station Screen - ZyXEL Communications MWR222 - V1.0 Manual

9.10

WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this
screen, click Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Figure 64 Network > Wireless LAN > WPS
Station
The following table describes the labels in this screen.
Table 39 Network > Wireless LAN > WPS Station
LABEL DESCRIPTION
Use this button when you use the PBC (Push Button Configuration)
method to configure wireless station's wireless settings.
Push Button
Click this to start WPS-aware wireless station scanning and the
wireless security information synchronization.
Use this button when you use the PIN Configuration method to
configure wireless station's wireless settings. Type the same PIN
Or input
number generated in the wireless station's utility. Then click Start to
station's PIN
associate to each other and perform the wireless security information
number
synchronization.
MWR222 User's Guide
97