Quick Setup - Printronix SL5000r User Manual

Chapter 3

QUICK SETUP

QUICK SETUP
QUICK
SETUP
(from page 95)
Print Print
Intensity Speed
-3*
6 ips*
-15 to 15 1 ips to 10 ips
Label
11
Width
2, 4
4.1, 6.6, or 8.5 inches*
4
00.1 to 8.5 inches
Auto Calibrate Validator
Funct.
Run Calibrate Enable*
Disable
Notes:
* = Factory Default
PAA: Select
1
9
Tool
None*
2
CST-1
CST-2
3
4
5
6
7
8
9
10
11
Small Label Printer is installed..
106
Print Media
10
Mode Handling
Transfer* Tear-Off Strip*
1
Direct Tear-Off
Peel-Off
Cut
Continuous
Ver Image Hor Image
Shift Shift
2
0.00 inches 0.00 inches*
3
-1.00 to X inches -1.00 to 1.00 inches
Active IGP Save Config.
7
Emul
IGP/PGL* 1*
PPI/ZGL 1-6
PPI/TGL
PPI/IGL
PPI/STGL
PPI/DGL
IGP/VGL
Maximum value depends on the printer model width (4, 6, or 8 inches) and printhead
(203 or 300 dpi).
You can change the unit value from inches to millimeters under Units (in MEDIA
CONTROL) when Admin User is enabled.
Based on the current value setting for the Label Length (in QUICK SETUP), up to a
maximum of 12.80 inches.
Maximum value depends on the width of the printer model (see Appendix A,
"Specifications").
Maximum value depends on model width and size of DRAM installed (see Appendix A,
"Specifications").
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown in Table 6 on
page 138. If you change the Gap/Mark Sensor or Paper Out Sensor, you must
recalibrate the media.
Appears only if a validator is installed.
Appears only if RFID is installed and there is no CST bundle in the Flash File System.
Appears only if RFID is not installed and there is a CST bundle in the Flash File System.
This menu will not appear on Direct Thermal only printers.
Resolution changes based on "Label Resolution" menu under MEDIA CONTROL if
Paper Feed Label
Shift Length
2
0.00 inches* 4 or 6 inches*
3
-0.50 to X inches
00.1 to 99.0 inches
Orientation Gap/Mark
Sensor
2
Portrait* Disable*
Landscape Mark
Inv. Portrait Gap
Inv. Landscape Advanced Gap
Advanced Notch
Power-Up SMT: Status
Config.
Factory* Disable*
1-8 Enable
11
2, 4
5
6
8