Translation Tbl - Printronix P7000 User Manual

Compatibility
Op
(from page 109)
CR At NL At
MPP+1 MPP+1
On* On*
Off Off
Auto Skip
FF After Job
At End
Off*
Off*
On On
Char Set Select
Specifies the print language used by the printer. Character sets are shown in
detail in the Character Sets Reference Manual.

Translation Tbl

Prints out SCS and DSC/DSE tables of the Coax interface's current character
set. This operation is valid only when the Coax interface is selected as the
current interface (see
Active Char Set
Selects which group of character sets (Primary or Secondary) will be active.
Secondary Set is the default.
Prt Partial Line
•
Enable (default). Forces the printer to print if a partial line is in the printer
(i.e., line not ending with a LF).
•
Disable. The last partial line of data will not be printed.
PA1
PA1 is only valid when the printer is in the offline state and the coax Systems
Network Architecture Character String (SCS) data stream is active. This
function displays the "PA1 ENABLED" message when the ENTER key is
pressed and sends a special operator request to the host when the printer is
put back in Online mode. Refer to the Coax/Twinax Programmer's Reference
Manual for more information about SCS.
NOTE: Selecting the PA1 menu item again ("PA1 DISABLED" appears on the
operator panel) or selecting the PA2 menu item will reset the pending
PA1 function.
Position Aft FF Last Char = FF
(4234 only)
Off* On*
On Off
CR, EM & NL
(3287 only)
On*
Off
ΗΟΣΤ ΙΝΤΕΡΦΑΧΕ − Π7000 ον παγε 74
Coax Emulation
* = Factory Default
Null FF Validity
Suppression
Off* Off*
On On
).
111