Icom IC-2200H Instruction Manual page 43

Channel names can also be programmed via the mi-
crophone.
z Select the memory/call channel to be assigned memory
names.
➥ Push [MR/CALL] to select memory mode, then select
the desired memory channel via [Y Y ]/[Z Z ] or keypad.
• Scan edge channels can also be selected.
➥ Push [MR/CALL] for 1 sec. to select the call channel.
x Push [FUNC], then [
MONI
c Push [
B(D-OFF)].
SET
• Frequency readouts disappear.
v Push [Y Y ]/[Z Z ] to select the desired character.
• The selected character blinks.
[EXAMPLE]: Programming "CLUB" into memory channel 15.
Select memory channel 15,
push , then push .
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
1(ANM)] momentarily.
Push to select the character.
MUTE
NAR
MID
LOW
LOCK ANM DUP
S ET MONI LOW
b Push [
B(D-OFF)] or [
SET
sor to left or right, respectively.
n Repeat steps v and b until the desired channel names
are displayed.
m Push [
A(MW)] to program the name and exit the
CLR
channel name programming condition.
, Push [FUNC], then push [
quency indication if desired.
Push or to move
the cursor.
Repeat
previous
MUTE
NAR
steps.
MID
LOW
LOCK ANM DUP
S ET MONI LOW
MEMORY OPERATION
C(T-OFF)] to move the cur-
ENT
1(ANM)] to return to fre-
MONI
Push .
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
5
5
30