Setting A Frequency; I Preparation; I Using The Tuning Dial - Icom IC-2200H Instruction Manual

2

SETTING A FREQUENCY

I Preparation

D Turning power ON/OFF
Push [PWR] for 1 sec.
D VFO mode selection
The transceiver has 2 basic operating modes: VFO mode and
memory mode.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
➥ Push [VFO/LOCK] to select VFO mode.
VFO/LOCK
9
➥ Push [PWR] for 1 sec. to
turn power ON and OFF.
➥ Push [V/MHz
SCAN
select VFO mode.
PRIO SCAN
M/CALL V/ MHz

I Using the tuning dial

qRotate [DIAL] to set the frequency.
• If VFO mode is not selected, push [V/MHz
mode.
• The frequency changes according to the selected tuning steps.
(p. 11)
wTo change the frequency in 1 MHz (10 MHz for some ver-
] to
sions) steps, push [V/MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
The display shows that the
1 MHz tuning step is selected.
Note that in this manual, sections beginning with a micro-
phone icon (as above), designate operation via the HM-
133V microphone.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET
MONI LOW TONE
[DIAL]
SCAN ] to select VFO
SCAN ], then rotate [DIAL].
• Pushing [V/MHz
1 sec. starts scan function.
If scan starts, push [V/MHz
PRIO SCAN
SCAN ] again to cancel it.
M/CALL V/ MHz
PRIO SCAN
M/CALL V/ MHz
] for
SCAN