I Scan Resume Condition; Scan Operation - Icom IC-2200H Instruction Manual

I Scan resume condition

The scan resume condition can be selected as timer or pause
scan. The selected resume condition is also used for priority
watch. (p. 44)
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO
S ET MONI LOW TONE M/CALL
q Push [SET
LOCK ] to enter set mode.
w Push [SET] or [MONI] several times until "SCT" or "SCP"
appears as shown above.
• When "d" is displayed in place of the 100 MHz digit, cancel the
DTMF memory encoder in advance. (p. 46)
e Rotate [DIAL] to set the desired timer:
• "SCT-15" : Scan pauses 15 sec. while receiving a signal.
• "SCT-10" : Scan pauses 10 sec. while receiving a signal.
• "SCT-5" : Scan pauses 5 sec. while receiving a signal.
• "SCP-2" : Scan pauses until the signal disappears and then
resumes 2 sec. later.
r Push any keys than [SET] or [MONI] to exit set mode.
The display shows that
the scan will resume
15 sec. after it stops.
SCAN
V/ MHz

SCAN OPERATION

z Push [
B(D-OFF)] to enter set mode.
SET
SET
x Push [
B(D-OFF)] or [
SET
B
times until "SCT" or "SCP" appears as shown at
left.
c Push [Y Y ] or [Z Z ] to select the scan resume condi-
tion.
• See item e at left for scan resume condition details.
v Push [
A(MW)] to exit set mode.
CLR
NOTE:
Set mode cannot be accessed when memory names are
displayed. To set the scan resume condition, return to fre-
quency indication by pushing [MONI
panel for 1 sec., or push [FUNC] then [
133V) to cancel the channel name indication, then set as
described on this page.
7
SET MODE
USING
C(T-OFF)] several
ENT
7
ANM ] on the front
1(ANM)] (HM-
MONI
42