I Offset Frequency; I Repeater Lockout - Icom IC-2200H Instruction Manual

4
REPEATER OPERATION

I Offset frequency

When communicating thorough a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
q Push [SET
LOCK
w Push [SET] or [MONI] until "±" and offset frequency appear.
e Rotate [DIAL] to set the desired offset frequency.
• Push [V/MHz] to select the 1 MHz tuning steps.
r Push any key other than indicated function keys to exit
set mode.
z Push [
SET
SET
x Push [
SET
B
and offset frequency appear.
c Push [Y Y ] or [Z Z ] to set the desired offset.
• Direct frequency entry from the keypad is not possi-
ble.
v Push [
CLR
21
SET MODE
USING
] to enter set mode.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
[DIAL]
B(D-OFF)] to enter set mode.
B(D-OFF)] or [ C(T-OFF)] until "±"
ENT
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
Push
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
A(MW)] to exit set mode.

I Repeater lockout

This function helps prevent interference to other stations by
inhibiting your transmission when a signal is received. The
transceiver has two inhibiting conditions, repeater and busy.
q Push [PWR] to turn power OFF.
w While pushing [SET
tial set mode.
PRIO SCAN
M/CALL V/ MHz
e Push [SET] or [MONI] several times until the "RLO" dis-
play appears as shown below.
r Rotate [DIAL] to turn the repeater lockout function to "RP,"
"BU" or OFF.
MUTE
NAR
MID
LOW
LOCK ANM
S ET MONI
PRIO SCAN
• "RP": Transmit is inhibited when a signal with un-matched sub-
M/CALL V/ MHz
audible tone is received.
• "BU": Transmit is inhibited when a signal is received.
t Push [PWR] to exit initial set mode.
INITIAL SET MODE
USING
LOCK ], turn power ON to enter ini-
[SET LOCK ]
[PWR]
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
DUP T-SCAN PRIO SCAN LOCK ANM
LOW TONE M/CALL V/ MHz S ET MONI
DIGITAL PRIO AO BUSY
DUP T-SCAN PRIO SCAN
LOW TONE M/CALL V/ MHz