I Memory Clearing - Icom IC-2200H Instruction Manual

5
MEMORY OPERATION

I Memory clearing

Contents of programmed memories can be cleared (blanked),
if desired.
q Push [V/MHz
SCAN
w Push [S.MW
MW
• "M" indicator and the memory channel number blink.
e Rotate [DIAL] to select the memory channel to be cleared.
• Memory channels not yet programmed are blank.
[EXAMPLE]: Clearing memory channel 20.
( )
SCAN
Push to select VFO.
V/ MHz
MUTE
NAR
MID
LOW
LOCK ANM DUP
S ET
MONI LOW
S.MW
MW
Push momentarily, then push
31
] to select VFO mode.
] momentarily.
Push
DIGITAL PRIO AO BUSY
T-SCAN PRIO SCAN
M/CALL
TONE V/ MHz
S.MW
MW
again for 1 sec.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO
S ET MONI LOW TONE M/CALL
r Push [S.MW
again for 1 sec.
This operation must be performed within 1.5 sec.
• 3 beeps sound, then the frequency is cleared.
• "M" indicator blinks continuously.
• When clearing the call channel, the current VFO conditions are
re-programmed into the call channel automatically.
t Push any key, except [S.MW
mode.
NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled.
S.MW MW
momentarily.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET M/CALL
MONI LOW TONE V/ MHz
Push any other keys than
"
"
Beep
MUTE
"
Beep NAR
MID
"
Beep
LOW
SCAN LOCK
"
V/ MHz S ET
MW ] momentarily, then push [S.MW
], to return to VFO
MW
Rotate for selecting memory channel..
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET
MONI LOW TONE
S.MW
MW
.
DIGITAL PRIO AO BUSY
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/ MHz
MW ]
PRIO SCAN
M/CALL
V/ MHz