t Push [MONI]
(or [SET])
[DIAL] to set the desired character or code.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for programming station/repeater call sign.
MUTE
NAR
MID
LOW
LOCK
ANM
DUP
S ET
MONI
LOW
y Push [V/MHz] to fix the call sign.
u Rotate [DIAL] to select an another channel from "C1" to
"C6."
i Repeat steps w to y to program another station/repeater
call sign channels.
✔ For your information:
Station and/or repeater call sign can be programmed from
Received call record when a call is received.
See page 64 for details.
✔ For your information:
Repeater call sign can be programmed gateway connection
capabilities at step r for connecting to the other Area or
Zone.
• "G" appears or disappears at the 8th digit when each pushing [LOW].
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK
ANM
DUP
T-SCAN
S ET
MONI
LOW
TONE
to select 2nd digit, then rotate
DIGITAL PRIO AO BUSY
T-SCAN
PRIO
SCAN
TONE
M/CALL
V/ MHz
PRIO
SCAN
M/CALL
V/ MHz
DIGITAL MODE OPERATION
z Push [BANK/OPTION] for 1 sec. then
BANK/OPTION
push [BANK/OPTION] or [MR/CALL] to
select the call sign select mode.
• "YUC" appears for station call sign.
• "R1C" or "R2C" appears for repeater call sign.
x Push [Y Y ] or [Z Z ] to select the desired call
sign channel then push [
c Push [
SET
programming mode.
• The 1st digit blinks and channel indication
stops blinking.
v Push [Y Y ] or [Z Z ] to set the desired charac-
ter or code.
• Push [
SET
move the cursor to left or right, respectively.
b Push [
B(D-OFF)] or [
SET
select 2nd digit, then push [Y Y ] or [Z Z ] to set
the desired character or code.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming your call
sign.
n Push [
CLR
exit programming condition.
NOTE: The digital repeater for an amateur radio operation is
not available at present of December 2003. It will be de-
signed in the future.
12
B(D-OFF)].
SET
B(D-OFF)] to set into call sign
B(D-OFF)] or [
C(T-OFF)] to
ENT
C(T-OFF)] to
ENT
A(MW)] to fix the call sign and
12
60
Need help?
Do you have a question about the IC-2200H and is the answer not in the manual?