I Scan Edges Programming - Icom IC-2200H Instruction Manual

7
SCAN OPERATION

I Scan edges programming

Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 1A/1b to 3A/3b, in memory channels.
q Set the edge frequency of the desired frequency range in
VFO mode:
➥ Set the frequency using [DIAL].
➥ Set other data (e.g. repeater settings, etc.) if desired.
w Push [S.MW
MW
• "M" indicator and channel number blink.
e Rotate [DIAL] to select one of scan edge channel, 1A, 2A
or 3A.
[EXAMPLE]: Programming 145.300 MHz into scan edges 1A.
( )
SCAN
Push
V/ MHz
MUTE
NAR
MID
LOW
LOCK ANM DUP
S ET MONI LOW
Rotate
MUTE
NAR
MID
LOW
LOCK ANM
S ET
MONI
39
] momentarily.
Rotate for setting frequency, etc.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
T-SCAN PRIO SCAN LOCK
TONE M/CALL V/ MHz
DIGITAL PRIO AO BUSY
DUP T-SCAN PRIO SCAN
TONE M/CALL V/ MHz
LOW
r Push [S.MW
• 3 beeps sound and VFO is automatically selected.
• Scan edge 1b, 2b or 3b is automatically selected when continu-
ing to push [S.MW
t To program a frequency for the other pair of scan edges,
1b, 2b or 3b, repeat steps q and r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
DIGITAL PRIO AO BUSY
ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
S.MW
MW
Push for 1 sec.
➠
and continue to push
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO
S ET MONI LOW TONE M/CALL
MW ] for 1 sec. to program.
MW ] after programming.
S.MW MW
Push momentarily.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
"
"
Beep
MUTE
"
Beep NAR
MID
"
Beep
LOW
SCAN LOCK ANM DUP
"
V/ MHz S ET MONI LOW
PRIO SCAN
M/CALL V/ MHz
DIGITAL PRIO AO BUSY
T-SCAN PRIO SCAN
TONE M/CALL V/ MHz