Programming A Memory Channel Via The Microphone - Icom IC-2200H Instruction Manual

D Programming a memory channel via the microphone
The microphone can also be used to program mem-
MW
ory channels.
z Set the desired frequency in VFO mode.
➥ Push [VFO/LOCK] to select VFO mode.
➥ Set the frequency using the keypad.
➥ Set other data
(e.g. offset frequency, duplex direction, sub-
audible tone encoder ON/OFF and its frequency)
sary.
x Push [FUNC] then [
A(MW)] momentarily.
CLR
c Select the memory channel to be programmed.
➥ Push [Y Y ] or [Z Z ] to select the memory channel
meral input cannot be used)
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the microphone.
Push
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO SCAN
S ET MONI LOW TONE M/CALL V/ MHz
Push
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
, if neces-
(direct nu-
.
Push
MUTE
NAR
MID
LOW
LOCK ANM DUP
S ET MONI LOW
Push
and continue to push
MUTE
NAR
MID
LOW
PRIO SCAN LOCK ANM
M/CALL V/ MHz S ET MONI
v Push [FUNC] then [
➥ 3 beeps may sound and the VFO contents (including
the subaudible tone frequency, etc.) are programmed.
➥ Memory channel number increases when continuing to
push [ A(MW)] after programming.
CLR
Push
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
T-SCAN PRIO SCAN LOCK
TONE M/CALL V/ MHz S ET
then 1 sec.
➠
"
"
DIGITAL PRIO AO BUSY
Beep
"
Beep
" Beep
DUP T-SCAN PRIO SCAN
"
LOW TONE M/CALL V/ MHz
MEMORY OPERATION
A(MW)] for 1 sec. to program.
CLR
then momentarily.
DIGITAL PRIO AO BUSY
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO
S ET MONI LOW TONE M/CALL
5
5
SCAN
V/ MHz
26