I Tuning Step Selection - Icom IC-2200H Instruction Manual

2
SETTING A FREQUENCY

I Tuning step selection

Tuning steps are the minimum frequency change increments
when you rotate [DIAL] or push [Y Y ]/[Z Z ] on the microphone.
The following tuning steps are available.
• 5 kHz • 10 kHz
• 20 kHz • 25 kHz
NOTE: For convenience, select a tuning step that matches
the frequency intervals of repeaters in your area.
15 kHz tuning step
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
11
• 12.5 kHz • 15 kHz
• 30 kHz • 50 kHz
q Push [V/MHz
SCAN
lect VFO mode, if neces-
sary.
w Push [SET
LOCK
[DIAL]
set mode.
e Push [SET] or [MONI] sev-
eral times until "TS" appears
as shown at left.
r Rotate [DIAL] to select the
PRIO SCAN
M/CALL V/ MHz
desired tuning step.
t Push any key other than in-
dicated function keys to exit
set mode.
VFO/LOCK
] to se-
] to enter
USING
z Push [VFO/LOCK] to select VFO mode, if
necessary.
x Push [
B(D-OFF)] to enter set mode.
SET
c Push [
B(D-OFF)] or [
SET
several times until "TS" appears.
v Push [Y Y ] or [Z Z ] to select the desired tun-
ing step.
b Push [
A(MW)] to exit set mode.
CLR
SET MODE
C(T-OFF)]
ENT