I Priority Watch Operation - Icom IC-2200H Instruction Manual

I Priority watch operation

q Select VFO mode; then, set an operating frequency.
w Set the watching channel(s).
For memory channel watch:
Select the desired memory channel.
For memory scan watch:
Select memory mode; then, push [V/MHz
1 sec. to start memory scan.
For call channel watch:
Select the call channel by pushing [M/CALL
or twice.
e Push [M/CALL
PRIO ] for 1 sec. to start the watch.
• The transceiver checks the memory or call channel every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 42)
• While the watch is pausing, pushing
the watch manually.
r Push [M/CALL
PRIO ] to stop the watch.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO
S ET MONI LOW TONE M/CALL
SCAN ] for
PRIO ] once
[M/CALL PRIO ]
resumes
While pausing or receiving
a signal on the memory or
call channel, "PRIO" blinks.
SCAN
V/ MHz
PRIORITY WATCH
z Select VFO mode; then, set an operating fre-
PRIO
quency.
3
x Set the watching channel(s).
For memory channel watch:
Push [MR/CALL] then [Y Y ] or [Z Z ] to select the
desired memory channel.
For memory scan watch:
Push [MR/CALL], then push [
memory scan.
For call channel watch:
Push [MR/CALL] for 1 sec. to select the call
channel.
c Push [
3(PTT-M)] to start the watch.
PRIO
• The transceiver checks the memory or call channel
every 5 sec.
• The watch resumes according to the selected scan re-
sume condition. (p. 42)
• To resume the watch manually when paused, push
[ 3(PTT-M)] or [
PRIO
v To stop the watch, push [
8
2] to start the
SCAN
A(MW)].
CLR
A(MW)].
CLR
8
44