Icom IC-2200H Instruction Manual page 72

12
DIGITAL MODE OPERATION
Your call sign programming—continued
z Push [BANK/OPTION] for 1 sec. then
BANK/OPTION
push [BANK/OPTION] or [MR/CALL] to
select the call sign select mode.
• "MYC" appears.
x Push [Y Y ] or [Z Z ] to select the desired call
sign channel then push [
c Push [
programming mode.
• The 1st digit blinks and channel indication
stops blinking.
v Push [Y Y ] or [Z Z ] to set the desired charac-
ter or code.
• Push [
move the cursor to left or right, respectively.
b Push [
select 2nd digit, then push [Y Y ] or [Z Z ] to set
the desired character or code.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming your call
sign.
n Push [
exit programming condition.
59
B(D-OFF)].
SET
B(D-OFF)] to set into call sign
SET
B(D-OFF)] or [ C(T-OFF)] to
SET ENT
B(D-OFF)] or [ C(T-OFF)] to
SET ENT
A(MW)] to fix the call sign and
CLR
D D Station/Repeater1/2 call sign programming
Station call sign must be programmed for the specified sta-
tion call as well as repeater operation in both Digital voice and
slow data communications.
q Push [BANK
OPT ] for 1 sec. then push [BANK
[V/MHz] several times to select the call sign select mode.
• "YUC" appears for station call sign.
• "R1C" or "R2C" appears for repeater call sign.
MUTE
NAR
MID
LOW
LOCK ANM DUP
S ET MONI LOW
w Rotate [DIAL] to select the desired call sign channel then
push [SET] or [MONI].
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
e Push
[MONI] (or [SET]) to set into call sign programming con-
dition.
• The 1st digit blinks and channel indication stops blinking.
r Rotate
[DIAL] to set the desired character or code.
• Push [MONI] or [SET] to move the cursor to left or right, re-
spectively.
OPT
DIGITAL PRIO AO BUSY
T-SCAN PRIO SCAN
TONE M/CALL V/ MHz
PRIO SCAN
M/CALL V/ MHz
] or