I Skip Channel Setting - Icom IC-2200H Instruction Manual

7
SCAN OPERATION

I Skip channel setting

The memory skip function speeds up scanning by checking
only those memory channels not set as skip channels. Set
skip channels as follows.
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
q Select a memory channel:
➥ Push [M/CALL
➥ Rotate [DIAL] to select the desired channel to be a skip
channel.
w Push [SET
LOCK
e Push [SET] or [MONI] several times until "CHS" appears
as shown above.
r Rotate [DIAL] to turn the skip function ON or OFF for the
selected channel.
• "~" appears : The channel is skipped during scan.
(CHS-ON)
• "~" disappears : The channel is scanned during scan.
(CHS-OFF)
t Push any key other than [SET] or [MONI] to exit set mode.
41
The display shows that
memory channel 15 is
set as a skip channel.
PRIO SCAN
M/CALL V/ MHz
PRIO ] to select memory mode.
] to enter set mode.
z Select a memory channel.
➥ Select memory mode by pushing [MR/CALL].
SET
B
➥ Push [Y Y ] or [Z Z ] to select the desired channel
to be a skip channel.
x Push [
B(D-OFF)] to enter set mode.
SET
c Push [
B(D-OFF)] or [
SET
times until "CHS" appears as shown at left.
v Push [Y Y ] or [Z Z ] to set or cancel the skip setting.
• See item r at left for skip indicator details.
b Push [
A(MW)] to exit set mode.
CLR
NOTES:
Even though scan edge channels cannot be set as skip
channels, they ARE skipped during memory scan.
SET mode cannot be accessed when memory names are
displayed. To set the scan resume condition, return to fre-
quency indication by pushing [MONI
panel for 1 sec., or push [FUNC] then [
133V) to cancel the channel name indication, then set as
described on this page.
SET MODE
USING
C(T-OFF)] several
ENT
ANM ] on the front
1(ANM)] (HM-
MONI