I Partial Reset; I All Reset - Icom IC-2200H Instruction Manual

13
OTHER FUNCTIONS

I Partial reset

If you want to initialize the operating conditions (VFO fre-
quency, VFO settings, set mode contents) without clearing
the memory contents, a partial resetting function is available
for the transceiver.
➥ Turn power OFF, if transceiver is powered ON.
➥ While pushing [V/MHz
tially reset the transceiver.
[PWR]
85
POWER ON
AT
SCAN ], turn the power ON to par-
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO
S ET MONI LOW TONE M/CALL

I All reset

The function display may occasionally display erroneous in-
formation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
• Partial resetting is also available. See left for details.
IMPORTANT!:
Resetting the transceiver CLEARS all memory information
and initializes all values in the transceiver.
SCAN
V/ MHz
➥ While pushing [SET
power ON to reset the CPU.
[S.MW MW] [PWR]
POWER ON
AT
LOCK ] and [S.MW MW ], turn the
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN PRIO
S ET TONE M/CALL
MONI LOW
SCAN
V/ MHz