I Break-In Communication - Icom IC-2200H Instruction Manual

12
DIGITAL MODE OPERATION

I Break-in communication

The break-in function allows you to break into an another sta-
tions communications in both Digital voice and slow data op-
eration.
q While receiving an another stations communication, push
[BANK OPT ] for 1 sec. to enter the option set mode, then
set the either station/repeater call sign into "MYC," "YUC,"
"R1C" and "R2C."
w Push [BANK
OPT
break-in setting, then turns the break-in setting ON.
• "BRK" appears.
DIGITAL
MUTE
NAR
MID
LOW
LOCK ANM DUP T-SCAN
S ET MONI LOW TONE
eWhen both stations are in standby, transmit to send a
break-in call.
• Programmed call sign station receives the break-in call as well
as your call sign.
rWait for the reply call from the station who receive the
break-in call.
t After receive the reply call, communicate normal way.
yTo cancel the break-in, push [BANK
rotate [DIAL] to turn OFF.
65
] or [V/MHz] several times to select the
PRIO AO BUSY DIGITAL
MUTE
NAR
MID
LOW
PRIO SCAN LOCK ANM DUP T-SCAN
M/CALL V/ MHz S ET MONI LOW TONE
OPT ] for 1 sec., then
BANK/OPTION
PRIO AO BUSY
PRIO SCAN
M/CALL V/ MHz
z While receiving an another stations com-
munication, push [BANK/OPTION] for
1 sec. to enter the option set mode, then
set the either station/repeater call sign into
"MYC," "YUC," "R1C" and "R2C."
x Push [BANK/OPTION] or [MR/CALL] sev-
eral times to select the break-in setting,
then turns the break-in setting ON.
• "BRK" appears.
c When both stations are in standby, trans-
mit to send a break-in call.
• Programmed call sign station receives the
break-in call as well as your call sign.
v Wait for the reply call from the station who
receive the break-in call.
b After receive the reply call, communicate
normal way.
n To cancel the break-in, push [BANK/OP-
TION] for 1 sec., then push [Y Y ] or [Z Z ] to
turn OFF.