Ipx Configuration Example - 3Com Switch 7700 Configuration Manual

Perform the following configuration in VLAN interface view.
Table 39 Enabling or Disabling Forward IPX Type 20 Broadcast Packets
By default, type 20 broadcast packets are not forwarded.
Displaying and Debugging IPX
After configuration, execute display command in any view to display the operation
of the IPX configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug IPX. Execute reset command in user
view to clear IPX statistics.
Table 40 Displaying and Debugging IPX
IPX Configuration In this example, Switch A, with the node address of 00e0-fc01-0000, is connected
Example to Switch B, with the node address of 00e0-fc01-0001, through an IPX network.
There is a server installed with NetWare 4.1 and assigned the network number of
2. On the server, the packet encapsulation format is set to Ethernet_II. The client is
a PC with the network number of 3 and the packet encapsulation format of SNAP.
Operation
Enable the forwarding of type 20 broadcast
packets
Disable the forwarding of type 20 broadcast
packets
Operation
Display the information of IPX on one or all
VLAN interfaces
Display the IPX packet statistics information
Display the IPX service information table
Display the IPX routing information
Clear the IPX statistics information
Clear the IPX routing table information
Disable/Enable IPX SAP debugging
Disable/Enable IPX packet debugging
Disable/Enable IPX ping debugging
Disable/enable IPX RIP debugging
Disable/Enable IPX triggered updates
debugging
Disable/Enable IPX interface debugging
Disable/Enable IPX routing table debugging
IPX Configuration
Command
ipx netbios-propagation
undo ipx netbios-propagation
Command
display ipx interface [ vlan-interface
vlan_id ]
display ipx statistics
display ipx service-table [ inactive | name
name | network network | order { network |
type } | type service-type ] [ verbose ]
display ipx routing-table [ network [
verbose ] | protocol { default | direct | rip |
static } [ inactive | verbose ] | statistics |
verbose ]
reset ipx statistics
reset ipx routing-table statistics protocol {
all | default | direct | rip | static }
[ undo ] debugging ipx sap [ packet [
verbose ] | event ]
[ undo ] debugging ipx packet [
vlan-interface vlan_id ]
[ undo ] debugging ipx ping
[ undo ] debugging ipx rip { packet [
verbose ] | event }
[ undo ] debugging ipx rtpro-flash
[ undo ] debugging ipx rtpro-interface
[ undo ] debugging ipx rtpro-routing
81