3Com MSR 50 Series Configuration Manual page 354

354 C 16: L A
HAPTER INK GGREGATION
n
C
ONFIGURATION
Network diagram
Figure 87 Network diagram for link aggregation
Link aggregation
Configuration procedure
This example only describes how to configure link aggregation on Device A. To
achieve link aggregation, do the same on Device B.
1 In manual aggregation approach
# Create manual aggregation group 1.
<DeviceA> system-view
[DeviceA] link-aggregation group 1 mode manual
# Add ports Ethernet 1/1 through Ethernet 1/3 to the group.
[DeviceA] interface ethernet 1/1
[DeviceA-Ethernet1/1] port link-aggregation group 1
[DeviceA-Ethernet1/1] interface ethernet 1/2
[DeviceA-Ethernet1/2] port link-aggregation group 1
[DeviceA-Ethernet1/2] interface ethernet 1/3
[DeviceA-Ethernet1/3] port link-aggregation group 1
2 In static aggregation approach
# Create static aggregation group 1.
<DeviceA> system-view
[DeviceA] link-aggregation group 1 mode static
# Add ports Ethernet 1/1 through Ethernet 1/3 to the group.
[DeviceA] interface ethernet 1/1
[DeviceA-Ethernet1/1] port link-aggregation group 1
[DeviceA-Ethernet1/1] interface ethernet 1/2
[DeviceA-Ethernet1/2] port link-aggregation group 1
[DeviceA-Ethernet1/2] interface ethernet 1/3
[DeviceA-Ethernet1/3] port link-aggregation group 1
Device A
Device B