Application Setup Wizard - Servotronix CDHD2S User Manual

Application Setup
The following figure shows the relationship between different memory types and the
commands used to manage drive parameters.
DriveFlashMem
ory
FLASH
Hardcodedfirmware
andfactorydefault
parametervalues
Non-volatile
user-defined
parametervalues
DriveFlashMem
ory
FLASH
Hardcodedfirm
ware
andfactorydefa
ult
Non-volatile
user-defined
parametervalues
Figure 6-1 Memory and parameter management commands
In ServoStudio2, drive parameters can be saved to non-volatile memory at any time by pressing
the save button in the toolbar.

6.2 Application Setup Wizard

The Application Setup wizard will guide you through the drive parameter setting procedure
according to the special application.
In the first step, the specific "Application Setup" procedure is defined via the selected "Interface
Mode". Subsequent steps may include PDO drawing, position unit definition, gear ratio, limit, return
and input and output functions.
When the software is offline, all "Interface Mode" will be displayed.
Note:
When the software is communicating with the drive, only relevant modes are displayed.
GUI–
SoftwareInterface
RestoreFact DriveRAM
ory
RAM
Defaults
Workingme
mory,holdspara
meter
valuesduring
onlineoperation
Save
VarCom-
Terminal
DriveR
AM
FACTORYREST
ORE RAM
Workingme
mory,holdspara
meter
LOAD
valuesduring
onlineoperation
SAVE
HostComp
uter
GUISoftwareIn
terface
Res
tore
FilesonPC
HostComp
uter
TerminalApplicatio
n
GUI–SoftwareInterface
SEPLink
HyperTerminal
DUMP
—122
—