Omron SYSMAC CJ - REFERENCE MANUAL 01-2008 Reference Manual page 231

Sequence Output Instructions
Example
192
the input device) can cause the operand bit of KEEP(011) to be reset. This sit-
uation is shown below.
The operands for KEEP(011) are input in a different order in ladder diagrams
and mnemonic code.
Ladder diagram order: Set input
Mnemonic code order: Set input
When CIO 000000 goes ON in the following example, CIO 00500 is turned
ON. CIO 00500 remains ON until CIO 000001 goes ON.
When CIO 000002 goes ON and CIO 000003 goes OFF in the following
example, CIO 00100 is turned ON. CIO 00100 remains ON until CIO 000004
or CIO 000005 goes ON.
Coding
Address
000100
000101
000102
000103
000104
000105
000106
000107
Note KEEP(011) is input in different orders on in ladder and mnemonic form. In lad-
der form, input the set input, KEEP(011), and then the reset input. In mne-
monic form, input the set input, the reset input, and then KEEP(011).
Input Unit
A
NEVER
A
KEEP(011)
Reset input
Instruction
LD
LD
KEEP (011)
LD
AND NOT
LD
OR
KEEP (011)
Section 3-4
S
KEEP
120000
R
Reset input
KEEP(011)
Operand
000000
000001
000500
000002
000003
000004
000005
000100