Omron SYSMAC CJ - REFERENCE MANUAL 01-2008 Reference Manual page 383

Data Movement Instructions
Operand Specifications
Description
344
D: First Destination Word
Specifies the first destination word. Bits are written from right to left, continu-
ing with consecutive words (up to D+16) when necessary.
Note The destination words must be in the same data area.
Area
CIO Area
Work Area
Holding Bit Area
Auxiliary Bit Area
Timer Area
Counter Area
DM Area
EM Area without bank
EM Area with bank
Indirect DM/EM
addresses in binary
Indirect DM/EM
addresses in BCD
Constants
Data Registers
Index Registers
Indirect addressing
using Index Registers
XFRB(062) transfers up to 255 consecutive bits from the source words (begin-
ning with bit l of S) to the destination words (beginning with bit m of D). Bits in
the destination words that are not overwritten by the source bits are left
unchanged.
The beginning bits and number of bits are specified in C, as shown in the fol-
lowing diagram.
15
D
to to
D+16 max.
C
CIO 0000 to CIO 6143
W000 to W511
H000 to H511
A000 to A959
T0000 to T4095
C0000 to C4095
D00000 to D32767
E00000 to E32767
En_00000 to En_32767
(n = 0 to C)
@ D00000 to @ D32767
@ E00000 to @ E32767
@ En_00000 to @ En_32767
(n = 0 to C)
*D00000 to *D32767
*E00000 to *E32767
*En_00000 to *En_32767
(n = 0 to C)
Specified values ---
only
DR0 to DR15 ---
---
,IR0 to ,IR15
–2048 to +2047, IR0 to –2048 to +2047, IR15
DR0 to DR15, IR0 to IR15
,IR0+(++) to 5+(++)
,–(– –) IR0 to, –(– –) IR15
Section 3-8
0
S D
A448 to A959
---