Installing An Expansion Card - HPE ProLiant MicroServer Gen10 Plus v2 User Manual

Expansion card options Expansion card options
The server supports the installation of half-height, half-length (low-profile) PCIe4 expansion / add-in (AIC) cards with maximum power draw
of 25 W.
A storage controller to enable advanced drive features .
A network adapter with advanced Ethernet connectivity features.
A single-width accelerator to meet your computational and graphics workload requirements.
Subtopics Subtopics

Installing an expansion card

Installing an expansion card
Installing an expansion card Installing an expansion card
Prerequisites Prerequisites
CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static- CAUTION:
sensitive devices. To prevent damage, observe antistatic precautions.
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Phillips No. 1 screwdriver—This tool is required if you plan to replace the default bracket on the expansion card.
Procedure Procedure
1. Power down the server.
2. Disconnect the power cord from the AC source.
3. Remove the power adapter cord from the power cord clamp, and then disconnect the power adapter from the server.
4. Disconnect all peripheral cables from the server.
5. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
6. If the server is in a vertical orientation, position the server in a horizontal orientation.
HPE ProLiant MicroServer Gen10 Plus v2 User Guide 53