HPE ProLiant ML110 Gen11 User Manual page 140

11. Make sure that all the system cables that are routed through the front cable channel are properly secured in the metal cable tabs and
cable clamps.
12. Install the system air baffle .
13. Install the access panel .
14. Do one of the following:
Orient the server back to tower mode.
Install the server into the rack.
15. Connect all peripheral cables to the server.
16. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
17. Power up the server.
Results Results
The installation is complete.
Installing an expansion card in the riser cage Installing an expansion card in the riser cage
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCIe slots have either a CAUTION:
riser slot blank or an expansion card installed.
HPE ProLiant ML110 Gen11 Server User Guide 140