HPE ProLiant ML110 Gen11 User Manual page 102

18. Install the system air baffle .
19. Install the access panel .
20. Do one of the following:
Orient the server back to tower mode.
Install the server into the rack.
21. Install the front bezel .
22. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
23. Power up the server.
Results Results
The installation is complete.
Transceiver option Transceiver option
Transceivers serve as the connection between the adapter and the network cable for maintaining high-speed performance.
Subtopics Subtopics
Transceiver warnings and cautions Transceiver warnings and cautions
Installing a transceiver Installing a transceiver
Transceiver warnings and cautions Transceiver warnings and cautions
WARNING: WARNING:
Fiber-optic transceivers and fiber-optic cables connected to transceivers emit laser light that can damage your eyes. To
avoid eye injuries, avoid direct eye exposure to the beam from the fiber-optic transceiver or into the ends of fiber-optic
cables when they are powered-up.
CAUTION: CAUTION:
The presence of dust in transceiver ports can cause poor cable connectivity. To prevent dust from entering, install a dust
plug in an unused transceiver port.
CAUTION: CAUTION:
Supported transceivers can be hot-swapped—removed and installed while the server is powered-on. However, to prevent
potential damage to the transceiver or the fiber-optic cable, disconnect the cable from the transceiver before hot-swapping
it.
CAUTION: CAUTION:
Do not remove and install transceivers more often than is necessary. Doing so can shorten the useful life of the transceiver.
HPE ProLiant ML110 Gen11 Server User Guide 102