Table of Contents
Advertisement
8. Remove the OCP slot blank:
a. Remove the blank screw.
b. Use a plastic spudger to pry the top side of the blank from the chassis.
c. Remove the blank.
9. Install the OCP NIC 3.0 adapter:
a. Rotate the locking pin to the open (vertical) position.
b. Slide the adapter into the bay until it clicks into place.
Make sure that the adapter is seated firmly in the slot.
c. Rotate the locking pin to the close (horizontal) position.
HPE ProLiant ML110 Gen11 Server User Guide
157
Advertisement
Table of Contents
