Minimum Firmware Versions - HPE ProLiant ML110 Gen11 User Manual

The capacitor pack can support up to two devices.
This server supports the HPE Smart Storage Hybrid Capacitor with the 260 mm cable.
Before installing the HPE Smart Storage Hybrid Capacitor, verify that the system BIOS meets the minimum firmware requirements to
support the capacitor pack.
IMPORTANT: IMPORTANT:
If the system BIOS or controller firmware is older than the minimum recommended firmware versions, the capacitor pack
will only support one device.
The capacitor pack is fully charged after the system boots.
Subtopics Subtopics

Minimum firmware versions

Minimum firmware versions
Minimum firmware versions Minimum firmware versions
Product Product
Server system ROM
HPE MR type-o and type-p Gen11 controllers 52.22.3-4650
HPE SR900 series type-p Gen11 controllers
Energy pack specifications Energy pack specifications
Feature Feature
Time required to recharge Smart Storage Battery
Duration of Smart Storage Battery backup
For more information, see the QuickSpecs document
Installing an energy pack Installing an energy pack
Prerequisites Prerequisites
Make sure that the following components are installed:
Compatible storage controller
Storage controller backup power cable
If you are installing the HPE Smart Storage Hybrid Capacitor, verify that the system meets the minimum firmware requirements .
About this task About this task
Minimum firmware version Minimum firmware version
1.30
03.01.14.062
QuickSpecs document for the Smart Storage Battery.
Description Description
12 W: 1 hour (For maximum load of 3 devices)
150 seconds (maximum support)
The Smart Storage Battery provides a sufficient duration to transfer
the cached data from DDR memory to flash memory, where the data
remains indefinitely or until a controller retrieves the data.
HPE ProLiant ML110 Gen11 Server User Guide 133