Accelerator Options - HPE ProLiant ML110 Gen11 User Manual

Table of Contents

Orient the server back to tower mode.

Install the server into the rack.

18. Connect all peripheral cables to the server.

19. Connect the power cords:

a. Connect each power cord to the server.

b. Connect each power cord to the power source.

20. Power up the server.

Results

The installation is complete.

Accelerator options

This server supports various accelerator options to meet your computational and graphics workload requirements. For a list of supported

accelerator models, see the server QuickSpecs on the Hewlett Packard Enterprise website (https://buy.hpe.com/us/en/p/1014705725

PCIe workload accelerators—These options are PCIe card–based, direct–attach solutions that use solid–state storage technology

directly on the PCI bus to boost I/O performance and reduce latency to scale in line with your processing requirements.

Computational and graphics accelerators—These options deliver accelerated compute performance for a range of deep learning, high–

performance computing (HPC), and graphics–intensive applications.

Subtopics

Accelerator installation guidelines

Installing an accelerator option in the riser cage

Accelerator installation guidelines

This server does not support the installation of different accelerator models in the same system.

To maintain proper system cooling, the redundant fan option kit is required for accelerator installation.

If an NVIDIA L4 Tensor Core graphic accelerator is installed, observe the following:

Processor with TDP equal or less than 150 W.

Accelerator support option kit (P66618-B21) is installed.

The limited operating inlet ambient temperatures required for accelerators vary based on the model and the server drive configuration.

For more information, see the server QuickSpecs on the Hewlett Packard Enterprise website

(https://buy.hpe.com/us/en/p/1014705725

https://buy.hpe.com/us/en/p/1014705725).

IMPORTANT: Workloads for high performance accelerators with passive cooling can cause the fans to operate at high

IMPORTANT:

speeds to maintain optimum system cooling. Hewlett Packard Enterprise does not recommend installing accelerators with

passive cooling in or near a site where there is a reasonable expectation for a quiet environment.

Installing an accelerator option in the riser cage

https://buy.hpe.com/us/en/p/1014705725).

HPE ProLiant ML110 Gen11 Server User Guide

145

Table of Contents