HPE ProLiant ML110 Gen11 User Manual page 95

Table of Contents

The server supports one USB RDX docking station in the media bay.

Subtopics

USB RDX backup system option

Install an RDX backup system as an inexpensive and portable way of storing data backups. The ruggedized design of this backup system

works especially well in harsh work environments. The backup system consists of two components:

RDX docking station

RDX cartridge

For more information on installing and configuring the RDX disk backup system, see the RDX product documentation:

https://www.hpe.com/info/rdx

Subtopics

Installing the internal USB RDX docking station

Prerequisites

Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.

About this task

CAUTION:

CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with

either a component or a blank.

CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-

CAUTION:

sensitive devices. To prevent damage, observe antistatic precautions.

Procedure

1. Back up all server data.

2. Power down the server.

3. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

4. Disconnect all peripheral cables from the server.

5. If installed, remove the front bezel .

6. Do one of the following:

If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .

If the server is in rack mode, remove the server from the rack.

7. Remove the access panel .

HPE ProLiant ML110 Gen11 Server User Guide

Table of Contents