6�27�- Programming Alarm 3 (Digital Output T1) - Circutor CVM-C11 Instruction Manual

6�27�- PROGRAMMING ALARM 3 (DIGITAL OUTPUT T1)
All values for digital output T1 are programmed on this screen.
The variable code is selected on this screen, depending on
control digital output T1.
Press key
To enter or modify the value, press the
When the desired value is shown on the screen, move onto the next digit by pressing the key
modify the other values.
When you enter the code of a variable on the display, the symbols for that variable will be activated.
To validate the data, press
Configuration values
Note: Set the value to 000 if you do not wish to program a variable.
Consumed Active Energy
Generated Active Energy
Consumed Inductive Reactive Energy
Generated Inductive Reactive Energy
Consumed Capacitive Reactive Energy
Generated Capacitive Reactive Energy
Consumed Apparent Energy
Generated Apparent Energy
Consumed CO
Generated CO
Consumption Cost
Generation Cost
No. of hours
If you have selected a parameter from
same as for alarm relay 1, see (
82
for 3 seconds to edit the value. The
for 3 seconds and the
Table 56: Parameter codes used to program digital outputs�
Parameter
Emissions
2
Emissions
2
Table 48
"6.25.- PROGRAMMING THE ALARM RELAY 1").
Table 48, Table 49
icon appears at the top of the screen.
key repeatedly, increasing the value of the flashing digit.
icon will disappear from the display.
Code Code
Tariff Tariff
T1 49 T2
T1 59 T2
T1 51 T2
T1 61 T2
T1 53 T2
T1 63 T2
T1 55 T2
T1 65 T2
T1 56 T2
T1 66 T2
T1 57 T2
T1 67 T2
T1 68 T2
or the subsequent programming steps are the
Table 49
and
Table 56,
Code
Tariff Tariff
70 T3 91 total
80 T3 101 total
72 T3 93 total
82 T3 103 total
74 T3 95 total
84 T3 105 total
76 T3 97 total
86 T3 107 total
77 T3 98 total
87 T3 108 total
78 T3 99 total
88 T3 109 total
89 T3 110 total
Instruction Manual
CVM-C11
which will
to
Code
112
122
114
124
116
126
118
128
119
129
120
130
131