6�25�2�- Minimum Value; 6�25�3�- Connection Time Delay - Circutor CVM-C11 Instruction Manual

Press key
6�25�2�- MINIMUM VALUE
On this screen, the value below which the alarm is activated is programmed.
Press key
To enter or modify the value, press the
When the desired value is shown on the screen, move onto the next digit by pressing the key
modify the other values.
In the case of some parameters (
press key
Press key
When the decimal point is in the desired position, press the key
now the key
Note: Pay special attention when programming the Generation Power (displayed with negative values).
Example: If you wish to enter a generation power alarm with limits between 2 kW and 1 kW, program
the following as the maximum value : - 1 kW and the following as the minimum value : - 2 kW.
To validate the data, press
Press key
6�25�3�- CONNECTION TIME DELAY
The alarm connection delay is programmed on this screen in seconds.
78
to access the next programming step.
for 3 seconds to edit the value. The
Table 48
after modifying the last digit and the decimal point will start flashing.
repeatedly to modify the position of the decimal point.
we can set a positive or negative value.
for 3 seconds and the
to access the next programming step.
icon appears at the top of the screen.
key repeatedly, increasing the value of the flashing digit.
), you can modify the position of the decimal point. To do so,
icon will disappear from the display.
to end the programming, pressing
Instruction Manual
CVM-C11
to