6�25�1�- Maximum Value - Circutor CVM-C11 Instruction Manual

CVM-C11
6�25�1�- MAXIMUM VALUE
On this screen, the value above which the alarm is activated is programmed.
Press key for 3 seconds to edit the value. The
To enter or modify the value, press the
When the desired value is shown on the screen, move onto the next digit by pressing the key
modify the other values.
In the case of some parameters (
press key after modifying the last digit and the decimal point will start flashing.
Press key repeatedly to modify the position of the decimal point.
When the decimal point is in the desired position, press the key
now the key we can set a positive or negative value.
Note: Pay special attention when programming the Generation Power (displayed with negative values).
Example: If you wish to enter a generation power alarm with limits between 2 kW and 1 kW, program
the following as the maximum value : - 1 kW and the following as the minimum value : - 2 kW.
To validate the data, press
Configuration values
Voltage
Current
Frequency
Power
Power factor
Cosine φ
Maximum current demand
Maximum power demand
THD
Instruction Manual
key repeatedly, increasing the value of the flashing digit.
), you can modify the position of the decimal point. To do so,
Table 50
for 3 seconds and the
Table 50: Decimal point and units of the alarm parameters�
Types of parameters
icon appears at the top of the screen.
to end the programming, pressing
icon will disappear from the display.
Units Decimal point
2000 kV
200.0 kV
Programmable
20.00 kV
2.000 kV
A Programmable
Hz Fixed
kW Programmable
PF Fixed
φ
Fixed
A Programmable
kW Programmable
% Fixed
to
77