Table of Contents
Advertisement
6.4.
RESETTING THE 4025 TO FACTORY DEFAULTS
!
TECHNICAL DESCRIPTION
There are three different methods of resetting the 4025 to factory defaults.
Under most circumstances the Toolbox method will work fine.
Proceeding with the Factory reset will cause all user configured parameters
including KeyKode head offsets, horizontal char size, user configurations,
etc. to be lost. We recommend that you write down your Head offsets for
PAL and NTSC and that you make a note of the settings shown on your
STATUS screen before proceeding.
6.4.1. Resetting The 4025 Using The Toolbox Hardware Menu
The FACTORY RESET item of the Toolbox HARDWARE menu is used to
reset the 4025 to the factory default parameters. Press SHIFT + ENTER
when the sub menu screen is displayed to reset the 4025 to factory
defaults. The 4025 will perform a power-on configuration before returning
to the normal operating mode.
6.4.2. Resetting The 4025 Using The Engineering Shortcut Keys
The 615 and 631 modules may be individually reset to their factory defaults
by using the Engineering shortcut keys. These functions are activated by
pressing the TIME/UB key and the SHIFT key plus the indicated key:
2
3
4
6.4.3. Resetting The 4025 Using The DIP Switches
The 631 module can be reset to factory defaults by the following
procedure.
1.
Move timecode & edge number displays to bottom of screen.
2.
Unplug the 631 or power down the 4025.
3.
Flip the DIP switches to the exact opposite of the current switch
4.
Push the 631 back in/or power up the 4025.
5.
Allow the 4025 to go through the normal power up displays.
6.
Check that 631 has reset the character windows to the top left
7.
With power on reset the 631 DIP switches to their original
settings.
Model 4025 Film Footage Encoder Manual
Reset 631 (right) board to factory defaults, and reboot
Reset 615 (centre) board to factory defaults, and reboot
Reset all boards to Factory defaults, and reboot
settings.
corner of the screen.
Page 6-14
Advertisement
Table of Contents
