Table of Contents
Advertisement
Model 8010TM SDI Time Code Master Manual
3.7.12.1. Setting the SDI Vertical Interval Blanking
SDI VBLANK END
Vbl end line 06
Vbl end line 23
Vbl end line 10
Vbl end line 20
3.7.13. Setting the NTSC Setup Pedestal on the Monitor Analog Output
NTSC SETUP
NTSC setup on
NTSC setup off
No setup in PAL
3.7.14. Downloading New Character Fonts
FONT DOWNLOAD
Shift+sel=start
3.7.15. Resetting the 8010TM to Factory Defaults
FACTORY RESET
Shift+sel=reset
Page 3-36
The SDI VBLANK END menu item is used to determine where the V bit
in the SDI TRS will be set to zero (indicating vertical blanking). If the V
blank bit is zero on a higher line number than the VITC is placed on,
some devices may discard the VITC.
For 525 systems the normal setting is for the vertical blanking to end at
line 10. If this causes problems with downstream devices, it can be set
to end at line 20; however some devices may blank the VITC if it is
placed prior to line 20.
For 625 systems, the normal setting is for the vertical interval to end at
line 6. If this causes problems with downstream devices, it can be set
to end at line 23, however some devices may blank the VITC if it is
placed prior to line 20.
The NTSC SETUP menu item is used to determine how the NTSC
Setup Pedestal will be applied on the Monitor Analog Output. The
NTSC setup pedestal should not be present when operating in Japan.
Select NTSC setup on to apply the Setup pedestal to all lines of the
active picture.
Select NTSC setup off to remove the NTSC Setup Pedestal from all
lines.
The FONT DOWNLOAD menu item is used to change the character
inserter font. For more information about uploading new font files see
section 5.4.
The FACTORY RESET menu item is used to return the 8010TM to its
factory defaults. When you press the or keys, the display shows
Shift+sel=reset. When you press SHIFT + SELECT the 8010TM will
reload its factory defaults and show the message:
Reset done
Revision 1.5.1
OPERATION
Advertisement
Table of Contents
