Generator Leds; Character Inserter Leds; Location Of Jumpers And Switches; I/O Board Jumpers - evertz 4025 Instruction Manual

6.3.

LOCATION OF JUMPERS AND SWITCHES

TECHNICAL DESCRIPTION

6.2.3. Generator LEDs

The LTC/VITC generator module pair is located in the centre slot of the
4025. There are two LEDs located at the front of this module.
OK The left LED indicates that the microprocessor is operating and
that it is communicating with the other modules.
The left LED is also used to indicate the presence of valid
KeyKode packets being received from an external KeyKode
reader device. The left LED will blink Off each time a keykode
data record is received from the external keykode reader
device.
GENLOCK The right LED indicates that the generator is properly
referenced to the genlock signal when it is On.
The right LED is also used to indicate the presence and correct
duty cycle and frequency of the Film Frame Advance pulse from
the telecine.
blinking, or dim, or flickering rapidly, this is an indication that the
Frame Pulse input is not satisfactory. See section 2.10.2 or
2.12.2 for information about connecting the film frame pulse.

6.2.4. Character Inserter LEDs

The character inserter module pair is located in the right slot of the 4025.
There are two LEDs located at the front of this module.
OK The left LED indicates that the microprocessor is operating and
that it is communicating with the reader module.
GENLOCK The right LED indicates that the generator is properly
referenced to the genlock signal when it is On.
Figure 6-2 to Figure 6-8 show the location and function of the switches and
jumpers inside the 4025. The jumper positions marked in bold face type
are the default settings used in the 4025.

6.3.1. I/O Board Jumpers

J22 Aux I/O Rxd
J24 Aux I/O Txd
J25 Aux I/O Select
Model 4025 Film Footage Encoder Manual
If the right hand LED on the 615 module is
Ser Configures Aux port (pin 8) for serial receive.
Par. Configures Aux port (pin 8) for parallel input
Ser Configures Aux port (pin 5) for serial transmit
Par. Configures Aux port (pin 5) for parallel output
RS232 Select Aux port (pin 5) For RS232 Transmit
+8v Select Aux port (pin 5) As +8 V DC source for
external use. (minimal current draw available!)
Page 6-4