Table of Contents
Advertisement
OPERATION
When you are using the 3 Line VITC STD generator assignment
the operation of some of the other menu items changes as
follows
1. The VITC LINES are set using the VITC1 LINES menu item.
2. The EDGE STYLE and EDGE FORMAT menu items are
When using the 3 Line VITC STD a special reader such as the Afterburner is
required to decode & display the film & production data.
3.3.2
Selecting the Line Numbers to Record VITC On
GEN VITC1 LINES
recorded on. Use the
line. Use the
When the using the 3 line VITC standard method of encoding,
GEN VITC1 LINES sets the line numbers for each block of 3
lines.
GEN VITC2 LINES
(containing full KeyKode information) will be recorded on. The
secondary VITC is only enabled when the GEN ASSIGN mode
is set to CINE
KEYKODE. Use the
line. Use the
3.3.3 Selecting the Generator Drop Frame Mode (NTSC Only)
DROP FRAME
generator in NTSC. This item is not available when in PAL.
Select NON DROP FRAME to operate the generator in the
NON DROP FRAME (sometimes called Full Frame) mode.
Select DROP FRAME to operate the generator in the DROP
FRAME mode. The colon between the seconds and frames of
the timecode will change to a period (.) to indicate Drop Frame
mode is active.
When the generator is set to the RDR1 RDR2 + KEYKODE or
RDR1 EDGE mode, the menu shows JAM RDR1. This means
Model 4025 Film Footage Encoder Manual
You can only select the lines in block of 3 lines as shown on
the menu item. The VITC2 LINES menu item is not used.
See section 0 for further information.
ignored as the 3 Line VITC standard defines the encoding
method. See section 0, 0 and 0 for further information.
Is used to set the lines that the primary VITC will be
&
keys to select the line number.
Is used to set the lines that the secondary VITC
RDR2 + KEYKODE or RDR1
&
&
keys to select the line number
Is used to select the drop frame mode for the
&
keys to select the first or second
keys to select the first or second
RDR2 +
Page 24
Advertisement
Table of Contents
