Table of Contents
Advertisement
OPERATION
value and press the ENTER key. Pressing the CLR key will cancel the
data entry mode without changing any data.
The numeric keys return to their normal functions, and the prefix digits stop
blinking when the data entry has been completed by pressing the ENTER
key or cancelled by pressing the CLR key.
Numeric entry mode must be terminated (the prefix digits will be on steady)
before any of the front panel keys will resume normal operation.
3.10.3 Entering Edge Code Prefixes Manually
When using ACMAID edge numbers, or when the KeyKode numbers are
not machine readable, it will be desirable to enter the edge code prefix
manually into the 4025.
Note that if the KK JAM mode of the 4025 is set to ONCE, PLAY, or ALWAYS,
the next valid data from the KeyKode reader will overwrite the data that was
manually entered from the front panel.
prevent this from happening.
When entering KeyKode prefixes, the 4025 automatically cross references
between the human readable manufacturer's ident and film emulsion letter
codes, and numeric codes that are contained in the machine readable
barcodes on the film.
When the 4025 generator is operating in one of EDGE modes, the prefix
information is only displayed in the character inserter, and will be sent to
the Key-Log logging software if it is running. When the 4025 is in one of
the Full KeyKode modes, the prefix information will also be encoded into
the secondary VITC.
When entering Film Edge number prefixes manually, make sure that the
generator is in one of the EDGE modes.
described in section 3.6.1 of the manual to select one of the EDGE modes.
Press the KKODE key and then the TIME/UB key to display the film
number prefix on the front panel. The ENTER and CLR keys are used in
conjunction with the arrow and numeric keys to set the film edge prefix.
Entering prefixes is a three step process.
manufacturer, then the film type, and then the numeric prefix. The chart in
Appendix C shows the supported manufacturer film types as of the printing
of this manual. Additional codes may be added in the future.
Press the ENTER key to recall the last film manufacturer code that you
entered. The leftmost digits of the display will indicate MANFCTR. The
KeyKode manufacturer letter from the human readable edge code is
displayed along with its numeric equivalent. Press the vertical arrow keys
( ,
) to select the correct manufacturer code. Hold the SHIFT key while
Model 4025 Film Footage Encoder Manual
Use the KK JAM OFF mode to
Use the format menu as
First you select the
Page 47
Advertisement
Table of Contents
