Connecting A Rank Cintel Ursa Gold; Verifying The Connections To A Rank Cintel Telecine - evertz 4025 Instruction Manual

INSTALLATION
For URSA telecines do not use AUTO rate detect.

2.10.6. Connecting A Rank Cintel URSA Gold

URSA Gold telecines with firmware versions 5.01 and earlier had some
indeterminate timing related to the Film Frame pulse (which is connected to
the 4025) and certain other internal telecine pulses. These inconsistencies
have been fixed in telecine firmware version 5.02 and later. Contact your
Rank Cintel agent if you are unsure of what telecine firmware version you
have, or how to upgrade to the latest version.
The Bi-phase tach pulse is available on a pair of BNC connectors on the
rear of the Mag follower. These bi-phase signals must be connected to
pins 3 & 7 of the 9 pin parallel I/O D connector. Connect ground to pin 6 on
the rear of the 4025. Retain the separate shielding of each signal up to the
4025 in order to prevent cross-coupling which can adversely affect the bi-
phase reliability.
Remove the coax cable connected to the Frame BNC (BSK 33) on the
telecine Digiscan frame, (if any) and connect it to one side of the FILM
FRAME loop on the 4025. Connect the other side of the FILM FRAME
loop to the Frame BNC (BSK 33)
Do not terminate this signal.
The telecine type item on the Engineering Toolbox Hardware Menu must
be set to URSA GOLD. The film frame item on the Engineering Toolbox
Hardware Menu must be set to DIRECT. (See section 3.6.4 and 3.6.5)
For URSA GOLD telecines do not use AUTO rate detect.

2.10.7. Verifying the Connections to a Rank Cintel Telecine

When you have completed the basic telecine connections, you will need to
verify the frame accuracy of the basic system. Once you have verified the
basic connections, you may proceed to the KeyKode reader installation.
If you do not verify the frame accuracy of the system at this time, the
accuracy of your system with KeyKode will also be affected.
The following simple procedure will help you establish that the 4025 is
properly installed, and that it is configured correctly for your application.
Model 4025 Film Footage Encoder Manual
Page 2-18