Resetting The Module To Its Factory Defaults; Resetting The Module To Factory Settings; Switching Encoder And Decoder Mode; Setting The Input Bypass Lock Mode - evertz 7772MFX-HD Manual

7700 MultiFrame Manual
7772MFX-HD JPEG2000 SD & HD Encoder and Decoder

6.6.3. Resetting the Module to its Factory Defaults

Miscellaneous
FRST
Reset All
Audio Control Reset
6.6.3.1.

Resetting the Module to Factory Settings

Resetting the module and its components to factory settings can be configured the same way. For the
sake of simplicity, only the reset menu for the Reset All will be described.
Miscellaneous
FRST
ALL
Yes
No

6.6.4. Switching Encoder and Decoder Mode

Miscellaneous
IMGS
No
To Decoder
To Encoder

6.6.5. Setting the Input Bypass Lock Mode

Miscellaneous
BPLO
Follow Input
Genlock
7772MFX-HD - 20
This control enables you to reset the entire module or certain
functional blocks to its factory default condition.
ALL
Select ALL to reset the entire module to the factory settings.
ACR
Select ACR to reset the Audio Control only to factory settings. All the
other module settings will remain the same.
With this control you can reset the entire module to its factory
settings.
Select YES to reset the module to the factory settings.
YES
NO
Select NO to not reset the module to factory settings.
Switches the card between encode or decode mode.
The 7772MFX-HD can be set as an encoder or a decoder.
NO
TDEC
Select NO to leave the mode unchanged.
TENC
Select TDEC (To Decoder) to change the encoder to a decoder.
Select TENC (To Encoder) to change the decoder to an encoder.
This control sets the reference for the input bypass. The two choices
are: Follow Input (INPU) and Genlock (GENL).
INPU
Genlock is the default and it is also the recommended bypass lock
GENL
mode.
Input genlock can be used when a fast switch from HD encode to SD
bypass is required.
Revision 1.2