Table of Contents
Advertisement
OPERATION
3.7.4
Setting the Full Stop Time
FULL STOP Is used to adjust length of time with no film motion
(measured in seconds and frames) before the 4025 detects a
Full Stop condition.
when the Full Stop Data packet is sent to a logging computer. It
is also used to determine when the auto centering function will
take place ( If auto centering is turned ON). The factory default
setting of 1:00 means that the 4025 will detect FULL STOP
when the film is stationary for at least 1 second. Use the
keys to adjust.
3.7.5
Setting the Centering Method
AUTO CENTRE
reframe its bi-phase counters when the telecine is in the full
stop condition. (See FULL STOP item above). Also see section
3.7.4.
When OFF is selected (the factory default setting) the 4025 will
only re-frame its bi-phase information when edge numbers or
absolute frames are entered from the front panel, or when the
centering remote input is closed to ground.
When ON is selected the 4025 will re-frame its bi-phase
information each time the telecine achieves a FULL STOP
condition.
3.7.6
Configuring the VCG field and Symbol Displays
VCG FIELDS Is used to select whether the field indicators will be used in
the character inserter.
When OFF is selected the 4025 field indicators on the time
displays will be turned off.
When ON is selected (the factory default setting) the field
indicators on the time displays will be on if the data being
displayed is from a VITC source.
VCG SYMBOLS
symbols will be used in the character inserter. Each symbol
character takes up one additional character in the window size
so some users may wish to turn off the symbols to simplify the
display.
3.7.7
Configuring the Operation of the Jam Sync Mode when
there is no Incoming Time Code
NO CODE JAM
generator in RDR1 EDGE or RDR1 RDR2 +KEYKODE modes
when the jam sync source timecode is no longer readable.
Model 4025 Film Footage Encoder Manual
This parameter is used in determining
Is used to select whether the 4025 will automatically
Is used to select whether the VCG window identifier
Is used to control the operation of the
&
Page 36
Advertisement
Table of Contents
